In this lesson, you create the candlestick shown below. This lesson demonstrates:
- Creating a revolve feature
- Creating a sweep feature
- Creating an extruded cut feature with a draft angle
文章源自LuckYou.ORG-https://luckyou.org/215.html
step1: sketching a revolve profile
when you are done dimensioning, the sketch is fully defined. you can see all lines and points are black. then you can creat the revolve feature文章源自LuckYou.ORG-https://luckyou.org/215.html
文章源自LuckYou.ORG-https://luckyou.org/215.html
step2: sketching the sweep path and sweep section.
文章源自LuckYou.ORG-https://luckyou.org/215.html
文章源自LuckYou.ORG-https://luckyou.org/215.html
step3: creating a extrued cut with a draft angle feature.
when you compete the whole part, then make the part transparent.文章源自LuckYou.ORG-https://luckyou.org/215.html
文章源自LuckYou.ORG-https://luckyou.org/215.html
文章源自LuckYou.ORG-https://luckyou.org/215.html 文章源自LuckYou.ORG-https://luckyou.org/215.html
Comments